Furuno FAR-3230SW-BB, Installation Manual

Page: 76 / 169

2. WIRING
2-40
2.6 Monitor Unit
For how to wire the monitor unit MU-231, see the operator’s manual supplied with the
monitor unit.
Mounting considerations
z Standard type
• Connect the radar main monitor to the DVI1 and COM1 ports.
• Connect the sub radar monitor to the DVI2 and COM2 ports.
z VDR connection, ask your dealer
To connect a VDR, it is necessary to output data in analog format. See the instal-
lation manuals for the VDR to prepare the cables to use. To connect a VDR to the
DVI3 port, use the optional DVI-BNCX5-L2000 cable to output the RGB signal from
the DVI-I. Adjustment of the output is necessary.
The [INSTALLATION SETTING] menu appears only when the power is turned on for
the first time after installation of the monitor unit.
Adjust the settings referring to the following table.
*: [DVI PWR SYNC] is the slide switch at the bottom rear of the monitor unit. Confirm
that this switch is set to [ON] (default setting). See Slide switch below for details.
EXT BRILL
CTRL
SERIAL BAUD
RATE
COLOR
CALIBRATION
KEY
LOCK
DVI PWR
SYNC*
RS-485 4800bps ON ON ON
INSTALLATION SETTING
EXT BRILL CTRL
SERIAL BAUDRATE
COLOR CALIBRATION
KEY LOCK
SAVE AND EXIT
RS-485
4800bps
ON
ON
YES
(OFF/DVI1/DVI2/RS-232C/RS-485/USB)
(4800/9600/19200/38400)
(OFF/ON)
(OFF/ON)
(NO/YES)
Menu
Menu item