Furuno FAR-3230S-BB, Installation Manual

Page: 38 / 139

2. WIRING
2-10
2.3 Processor Unit
Note: The interface ports approved for interconnecting navigation equipment are
shown in the figure below. For details, see paragraph 2.3.3 "How to select the serial
input/output format".
2.3.1 How to connect cables to terminals in the processor unit
Use screws (M3
×
6, supplied) to attach the wiring plate 1 and wiring plate 2 to the pro-
cessor unit. Connect the cables shown below to the connectors at the front of the pro-
cessor unit. Bind cables to the appropriate fixing metal with the cable ties (supplied).
For the cables from the monitor unit (type: DVI-D/D SLINK5M/10M* (*: MU-190 only),
DSUB9P-X2-L5/10M) and ground wire, connect them to the processor unit directly
(without fixing to a wiring plate). Tighten the fixing screws on these connectors to pre-
vent disconnection from the processor unit.
Note: Connect the cables so that they do not interfere with the opening or closing of
the DVD tray.
J5 J5 J5
J11 J11 J11
J4 J4 J4
J3 J3 J3
J8 J8 J8
J9 J9 J9
J10 J10 J10
J6 J6 J6
J7 J7 J7
J12 J12 J12
J13 J13 J13
J14 J14 J14
J3, J4
For IEC 61162-2 or
IEC 61162-1
J5, J6, J7, J8, J9, J10
For IEC 61162-1
Top view of EC-3000
OK
UP
Desktop or Bulkhead (Sideway slot)
Hanging or Bulkhead (Vertical slot)