Furuno FAR-3220W-BB, Installation Manual

Page: 78 / 185

2. WIRING
2-42
How to open the [INSTALLATION SETTING] menu
Turn off the monitor unit. While you hold the DISP key, press the BRILL key to turn on
the monitor unit. Keep the DISP key pressed until the [INSTALLATION SETTING]
menu appears.
Note: When the [DVI PWR SYNC] slide switch is ON, turn on the connected external
equipment while you press the DISP key to turn on the monitor unit.
2.7 Sensor Adapters (option)
A maximum of eight MC-3000S can be connected to a sensor network (for the redun-
dant connection: 16). The MC-3000S (serial input/output, IEC61162-2/1, 4ch) can
connect a maximum of 10 sensor adapters, using the MC1.5-W cables. The maximum
number of MC-3010A units is five.
When fabricating the MC1.5-W cables, use the lot terminal (ferrule type, supplied) to
maintain performance. Use the ferrule-type terminals (supplied) to connect the cables
to the terminals in the sensor adapters. This connection requires a crimping tool
(CRIMPFOX10S, option). For the relations between the connectors and rod terminals,
see page AP-2. Also, the stickers attached on the reverse side of the covers show the
detailed connections.
Attach the cables to the applicable pins.
Note 1: Use the MC1.5-W cable between the sensor adapters.
Note 2: The total length of the MC1.5-W cables must be less than 6 m to prevent mal-
function.
Pin no. Cable color Signal
1 Red 24V_OUT or 24V_IN
2 Black 24V_GND
3 White MODBUS-A
4 Blue MODBUS-B
5 Gray GND
Ferrule-type rod terminal:
After attaching the rod terminal, use the optional
crimping tool CRIMPFOX 10S to crimp.
L
0.5 to 1 mm
How to attach ferrule-type terminal
Core
Vinyl sheath
After attaching the rod terminal,
confirm that the core protrudes
0.5 to 1 mm past the terminal.
Ferrule-type terminal Length of “L”
AI 1.5-6 BK (BLK)
AI 0.34-6 TQ (BLU)
AI 0.75-6 GY (GREY)
AI 1-6 RD (RED)
6 mm
AI 0.14-8 GY(GREY) 8 mm