Furuno FAR 3220, Installation Manual

Page: 76 / 245

2. WIRING
2-34
13. Fasten the coaxial connector to the waveguide flange with three sets of M6

20
hex bolts, M6 spring washers and M6 nuts.
14. Tape the cable with two or more
turns of self-bonding tape then wrap
with PVC tape.
15. Secure the cable with fixing bands (supplied) or the op-
tional cable clamping fixture (Type: 03-011-3228) to the
mast and to the wheelhouse structure. For the optional
through-deck cable gland, see the outline drawing at the
back of this manual.
16. Reconnect the performance monitor connector (J807).
17. Check that the gasket on the front and rear cover is seated properly, then close
the covers. The torque for the fixing bolts must be 28.0 N•m.
Note: For the de-icer specifications, take care not to hit the heater elements on
the chassis or radiator. If the heater hits something, unfasten the fixing screws for
the heater to adjust the position of the heater. Then fix the heater again.
2.6 Processor Unit
Note: The interface ports ap-
proved for interconnecting navi-
gation equipment are shown in
the figure below. For details, see
section 2.6.3 "How to select the
serial input/output format".
REAR REAR REAR
Coat surface of flange with
waterproofing compound.
Hex bolt Spring
washer
Nut
5 cm
Coaxial
connector
Fixing band
ø7
Top view of EC-3000
J4 J4
J3 J3
J8 J8
J9 J9
J10 J10
J5 J5
J6 J6
J7 J7
J11 J11
J12 J12 J13 J13
J14 J14
J3 to J6
For IEC 61162-2 or IEC 61162-1
J7 to J10
For IEC 61162-1