Furuno DS-80, Installation Manual

Page: 9 / 84

3
F type
1. Make a cutout of 167 X 92 mm.
2. Attach the cosmetic panel (supplied) to the display unit with hex bolts (M6X12, supplied)
and spring washers (M6, supplied).
3. Fix the display unit to the mounting location with four tapping screws (5X20, supplied).
S type
1. Make a cutout 167 X 92 mm.
2. Attach two fixing metals (supplied) to the display unit with hex bolts (M6X12, supplied) and
spring washers (M6, supplied).
3. Screw four wing bolts (supplied) to wing nuts (supplied).
4. Fasten the display unit to the mounting location with four wing bolts and nuts assembled at
step 3.
1.3 Transceiver Unit
1.3.1 Mounting considerations
•
Since the transceiver unit generates heat, install it in a dry, well-ventilated place. The cooling
fans at the top of the unit must not be obstructed, to allow heat to escape.
•
This unit is designed for bulkhead mounting to permit dissipation of heat. If bulkhead
mounting is absolutely impossible, mount the unit on the floor leaving at least 50 mm
clearance between it and the floor to permit dissipation of heat.
•
The unit weights 7.1 kg. Reinforce the mounting area, if necessary.
•
Leave space around the unit for maintenance and checking. Refer to the drawing at the end
of this manual for minimum recommended maintenance space.
•
A magnetic compass will be affected if the transceiver unit is placed too close to it. Observe
the compass safe distances to prevent disturbance to the magnetic compass.
1.3.2 Mounting procedure
Fasten the transceiver unit with four tapping screws (6X30, supplied).
For bulkhead mounting, make sure there is 5 mm clearance between lower edge screw head
and bulkhead.