Furuno DS-60, Installation Manual

Page: 7 / 74

1-1
1. INSTALLATION
1.1 Display Unit DS-600
Mounting Consideration
The display unit can be installed on a desktop, on the underside of a table, or flush
mounted in a panel. When you select a mounting location, keep in mind the following
points:
Flush Mount
See the outline drawing in the back of this manual. Before you fasten the display unit
to the cutout, first connect the cables referring to chapter 2.
1. Make a cutout in the mounting location as shown in the illustration below.
Note: Dimensions for the cutout are different depending on the mounting location,
indoor or out-door. For the outdoor mouting, ask dockyard to construct a water-
proof case for the display unit.
• Locate the display unit away from exhaust pipes and vents.
• Select an installation location that is well ventilated.
• Locate the display unit where shock and vibration are minimal.
• Allow enough maintenance space at the sides and rear of the display unit and leave
enough slack in cables to facilitate maintenance and servicing.
• Observe the compass safe distances (see page i) to prevent the interference to a mag-
netic compass.
• The nominal viewing distance for the display unit is 1 m. Select a suitable mounting
location considering that distance.
NOTICE NOTICE
Do not apply paint, anti-corrosive sealant
or contact spray to coating or plastic
parts of the equipment.
Those items contain organic solvents that
can damage coating and plastic parts,
especially plastic connectors.
78 (3.07”)
12 (0.47”)
240 (9.45”)
240 (9.45”)
Pilot hole
(four places)
223+0.5 (8.78”) 223+0.5 (8.78”)
228+1 (8.98”)
(for outdoor)
228+1 (8.98”)
(for outdoor)
18 (0.71”)
18 (0.71”)
(for outdoor)
Fixing hole (4- 6)
232+1 (9.13”)
(for indoor)
232+1 (9.13”)
(for indoor)
22 (0.87”)
(for indoor)
or