Furuno Doppler Speedlog DS-510, Installation Manual, Page: 32 / 66

5.2 Cable Fabrication
25
5.2 Cable Fabrication
1. Transducer cable
Shorten considering location on terminal strip
Insulating tubing
FV1.25-4
FV1.25-4
FV1.25-4
Taping
Rubber gasket
Taping
Gland
To #16 terminal on terminal strip
Figure 5-1 Fabrication of transducer cable
2. Cable between transceiver unit, junction box and processor unit
(TTYCY-19S)
1) Transceiver unit/ junction box
Anticorrosive sheath
Rubber gasket
FV1.25-4
Washer
Armor
Note: 1. Unravel shield only
near terminal strip.
2. Fold back armor onto
washer and insert
between washer and
gland.
Figure 5-2 Cable fabrication
2) Processor unit
Cores and shields are fabricated the same as on transceiver unit/junction box side.
To ground the cable, remove paint from the armor and set the armor in the cable
clamp.
Figure 5-3 Cable fabrication