Furuno CSH-8LMARK-2, Installation Manual

Page: 3 / 85

i
SAFETY INSTRUCTIONS
WARNING
WARNING
ELECTRICAL SHOCK HAZARD
Do not open the equipment
unless totally familiar with
electrical circuits and service
manual.
Only qualified personnel are allowed
to work inside the equipment.
Turn off the power at the
switchboard before beginning
the installation.
Fire or electrical shock can result
if the power is left on.
Do not install the equipment other
than the transducer where they may
get wet from rain or water splash.
Water in the equipment can result in
fire, electrical shock or equipment
damage.
Be sure no water leaks in at the
transducer installation site.
Water leakage can sink the vessel.
Also confirm that the transducer will
not loosen by ship's vibration. The
installer of the equipment is solely
responsible for the proper installation
of the equipment.
FURUNO will assume no esponsibility
for any damage associated with
improper installation.
Install the specified transducer
tank in accordance with the
installation instructions. If a
different tank is to be installed
the shipyard is solely respon-
sible for its installation, and it
should be installed so the hull
will not be damaged if the tank
strikes an object.
The tank or hull may be damaged
if the tank strikes an object.
When assembling the hull unit,
fasten the shaft retainer and
fastening band with the torques
shown below.
Shaft retainer: 20 to 25 N•m
Fastening band: 6 to 8 N•m
If torques are less than the above,
water leakage may occur because
the shaft may loosen and fall.
Mandatory Action
Prohibitive Action
Warning, Caution
The operator must read the safety instructions before attempting to operate the equipment.
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
Indicates a potentially hazardous situation which, if not
avoided, could result in minor or moderate injury.
WARNING
CAUTION