FITELS123M12
Quick Reference guide
①
Turn on power.
< Fiber Preparation >
Stripping the Fiber Coating
Setting the Fiber in the Fiber Holder
Fiber Cleaning
Safety Instructions
Before operating this product, please read
the user’s manual of safety
instructions. The safety instructions are to help you use this product in a
safe and correct way, and to prevent danger or injury to yourself or others.
Splicing Procedure
⑫
Remove the fiber.
⑪
Press key.
⑩
Place fiber to heater.
⑨
Slide protection sleeve over
spiced point.
⑧
Remove spliced fiber.
⑦
Press key.
⑥
Set fibers to the splicer.
⑤
Prepare the fibers.
④
Insert protection sleeve.
③
Perform Arc Check.
※
Please see “Arc Check” for
details.
②
Select applicable program
*
.
Place the ribbon fiber into the fiber holder leaving
30mm of ribbon from the edge of the holder.
Use the S218R hot stripper to remove ribbon
fiber coating. For detailed information, refer
to the S218R operating instructions.
Clean the bare fiber with a lint free
wipe soaked with fiber prep fluid.
Fiber Cleaving
Place fiber holder into cleaver, then press the lever.
