Turn right (clockwise) to tighten
Page 6 of 6
Enlarged
Enlarged
#B x 4 pcs
#D x 4 pcs
#E x 4 pcs
I.
Align the central support rail
(#4) with the pre-drilled holes
on the center of the
headboard (#1) and the
footboard (#3).
II.
Prepare 4 bolt assemblies by
inserting FIRST the lock
washer (#E) onto the bolt
(#B) and then the flat washer
(#D) onto the SAME bolt
(#B), in that order.
III.
Insert the 4 bolt assemblies
through the brackets of the
central support rail (#4)
using the Allen wrench (#H)
to lock them in with the
headboard (#1) and the
footboard (#3).
I.
Prepare a complete bed slat
by inserting one center
plastic connector (#F) onto
the ends of two bed slats
(#6). Then connect two end
caps (#G) onto the other
ends of the bed slats (#6).
II.
Align the end caps (#G) with
the pre-drilled holes on
each side of the side rails
(#2) and snap both ends to
lock in place. Then snap
the center plastic connector
(F) onto the central support
rail (#4).
III.
Repeat the above process
for the remaining bed slats.
ASSEMBLY IS COMPLETED
#1
#3
Note: The correct position of the bed
slats should be arcing UPWARD when
placing on the rails.
#F x 13 pcs
#G x 26 pcs
Summary of Contents for CM7057F
Page 2: ...Page 2 of 6...
