I.
Align the base (#4) with the pre-
drilled holes on the stand A (#2)
and the stand B (#3).
II.
Prepare 4 bolt assemblies by
inserting FIRST the lock washer
(#D) onto the bolt (#C) and then
the flat washer (#E) onto the
SAME bolt (#C), in that order.
III.
Insert the bolt assemblies through
the holes of the base (#4) and
secure those bolts using the Allen
wrench (#F) to lock them with the
stand A (#2) and the stand B (#3).
Page 6 of 6
ASSEMBLY IS COMPLETED
#3
#2
I.
Carefully place the glass top (#1)
facing down on a protected surface.
II.
Align the short sides of the base
brackets (#G) assembled on the
stands with the pre-drilled holes on
the glass top (#1).
III.
Prepare 6 bolt assemblies by
inserting FIRST the lock washer
(#D) onto the bolt (#A) and then the
flat washer (#E) onto the SAME bolt
(#A), in that order.
IV.
Insert the bolt assemblies through
the holes of the base brackets (#G)
and secure those bolts using the
Allen wrench (#F) to lock them with
the glass top (#1).
V.
Place the table in its upright
position. Make sure the table is
rested on a flat surface and does not
feel loose or wobbly. If it does,
double check that the bolts/screws
are secured and properly tightened.
#A x 6 pcs
#D x 6 pcs
#E x 6 pcs
#C x 4 pcs
#D x 4 pcs
#E x 4 pcs
#G
Turn right (clockwise) to tighten
Turn right (clockwise) to tighten
Summary of Contents for CM4401E
Page 3: ...Page 3 of 6 ...
