Quick Install Guide
bintec User’s Guide
13
Configuration
3
Table 3-4:
Data for connection to a corporate network
3.1.2
Configure the PC
A number of conditions must be fulfilled at the PC with which you carry
out the configuration, before you can reach your gateway over the net-
work and configure it using the
HTML Wizard
.
Make sure the TCP/IP protocol is installed before you start the configuration.
Then you must assign a fix IP address to the PC to be able to set up a connec-
tion to the gateway.
Checking the TCP/IP
protocol
Proceed as follows to check whether you have installed the protocol:
1.
Click
Settings
➜
Network and Dial-up Connections
resp.
Control
Panel
➜
Network Connections
in the Start menu.
2.
Double click
LAN Connection
.
3.
Click
Properties
in the status window.
4.
Look for
Internet Protocol (TCP/IP)
in the list of network components.
Installing the TCP/IP
protocol
If you cannot find the entry
TCP/IP
, install the TCP/IP protocol as follows:
1.
First click
Properties
, then
Install
in the status window of the
LAN
Connection
.
2.
Select the
Protocol
entry.
3.
Click
Add
.
4.
Select
Internet Protocol (TCP/IP)
and click
OK
.
5.
Follow the instructions on the screen and finally restart your PC.
Assign PC an IP
address
Assign your PC an IP address as follows:
1.
Select
Internet Protocol (TCP/IP)
and click
Properties
.
2.
Select
Use the following IP address
and enter an IP address.
Netmask(s) of your head office
255.255.255.0
Access data
Example
Your value
quick_reference.book Page 13 Thursday, January 5, 2006 6:00 PM
Summary of Contents for R3000w
Page 25: ......
Page 26: ...R3x00_QI_1 1_en...
