Funkwerk elmeg t444, Operating Instructions Manual, Page: 17 / 84

Making external calls with prefix code
You wish to make a call to an external party.
b 0 t l g
Lift up
handset
Dial line access digit Dial external number Subscriber
is called
External call
If you hear the busy signal after dialing the first 0 your telephone either does not have authorization for making exter-
nal calls, or the external ISDN connection is busy.
Trunk group (routing discrimination)
You can only use this performance feature when you are using more than one external port (only with POTS module). In the default setting,
the external ISDN port is used first after dialing the line access digit. If this port is occupied, the external analog port is selected automatical-
ly. In the Configurator you can define which trunk group is to be used first when 2 trunk groups have been configured (ISDN and POTS).
Call waiting
Enable / Inhibit Call Waiting for a Further Call
Using the function »Call waiting« you can be called by other parties while conducting an ongoing call. When a second callers calls up you will
hear the call waiting signal in your handset and can then decide whether you want to continue your call with the current caller, or whether
you want to take the waiting caller right away.
Call waiting for external calls is possible with analog telephones. Please refer to the corresponding section in the operating instructions for
your ISDN terminals for proper use of this function.
If call waiting occurs during an ongoing call with an analog phone and you ignore the call waiting signal, it will be de-activated after around
30 seconds. You can also disable call waiting with analog telephones so that no call waiting signals are given during your calls.
Enable / inhibit call waiting
b *
/
# 58 q a
Lift up
handset
Enable announcements /
Inhibit announcement
Dial this code Ack.
signal
Replace
handset
Automatic completion of call
This function can only be used by telephones that permit suffix dialing! Automatic call completions from an inquiry call are not possible.
Automatic completion of call to busy subscriber
Let's assume that you must urgently contact a business partner or an internal extension. When you call their number you always get a busy
signal however. If you were to be provided with a message that the subscriber you are attempting to call has ended his/her call, this would in-
crease your chances of reaching that party considerably.
»Recall to busy subscriber« allows you to call the extension as soon as the other subscriber hangs up his or her telephone. Your telephone will
then ring. When you then lift your handset, a connection is set up automatically to that party.
An internal »Completion of call to busy subscriber« is deleted automatically after 30 minutes. The external »Completion of call to busy sub-
scriber« is deleted after a period defined by the exchange (around 45 minutes). You can also manually delete this function before this period
expires.
Automatic completion of calls on no reply
Let's assume that you must urgently contact a business partner or an internal extension. When you call their number you always get a rin-
ging signal, but the party is not near the phone or does not answer. If supported by your network provider, you can use the function »Com-
pletion of calls on no reply« to reach the party immediately when he/she ends a call, or lifts and then replaces his/her handset. Your telepho-
ne will then ring. When you then lift your handset, a connection is set up automatically to that party.
Trunk group (routing discrimination)
13