Field
Description
•
Active
: OSPF is activated for this interface, i.e. routes are
propagated or OSPF protocol packets sent over this interface.
•
Down
: OSPF is disabled for this interface.
Proxy ARP Mode
Select whether and how ARP requests from your own LAN are
to be responded to for the specified connection partner.
Possible values:
•
Inactive
(default value): Deactivates Proxy ARP for this
connection partner.
•
Active or Idle
: Your device only responds to an ARP re-
quest if the status of the connection to the connection partner
is
Up
or
Dormant
. In the case of
Idle
, your device only re-
sponds to the ARP request; the connection is not set up until
someone actually wants to use the route.
•
Active Only
: Your device responds to an ARP request only
if the status of the connection to the connection partner is
Up
(active), i.e. a connection already exists to the connection
partner.
DNS Negotiation
Select whether your device receives IP addresses for primary
DNS server, secondary DNS server, primary WINS and sec-
ondary WINS from the connection partner or sends these to the
connection partner.
The function is activated with
Enabled
.
The function is enabled by default.
10.1.5 GPRS/UMTS
Note
Note that the GPRS/UMTS menu is only available if a UMTS modem card is inserted
in the CardBus slot and is integrated in the system! Not all bintec gateways have a
CardBus interface. Refer to the data sheet to determine whether your gateway has this
interface type.
In the WAN -> In Dialup -> GPRS/UMTS menu, a list of all GPRS/UMTS inter-
faces is shown.
Funkwerk Enterprise Communications GmbH
10 WAN
bintec R1xxx/R3xxx/R4xxx
277
