Personal Emergency Signal (PES) Functions
Localisation functions
122
Guard Control
The Guard Control mode is used to log check points during a patrol when you are
performing a guard function. The radio set can be programmed with the settings
required for this purpose. During programming it can be defined which emergency
signal functions shall be active in the radio set.
With the Guard Control mode active, the radio set will react as follows if it receives
the code of an inductive localisation beacon (ILB), of a BT beacon or GPS/GNSS
position data:
The code is signalled acoustically (if programmed).
The code is displayed on the display (if programmed).
The code is transmitted to the personal emergency signal centre.
Note:
The Guard Control function is only possible in “TMO mode” and logged in while
in “Security mode”
TIP
Radio sets with active warden control mode are typically specially marked. If neces-
sary, ask the responsible system administrator of the personal emergency signal
system whether the Guard Control mode is activated on your radio set.
