ATR833S / P/N 833S-(Cxxx)-(Cxxx)
Operation and Installation
46
Document-Nr.: 01.142.010.71e / Revision:1.03
4.11.2 Mounting Advice
For mounting in panels with a thickness of up to 5 mm use the fastening
screw M4x8 (ZUB3).
Dimensions in
connector area
Dimensions of
panel cut-out
No screws may be turned in more than max. 10 mm into the
device
– even if no hard limit is noticeable!
Caution: If a screw is used that is too long it is likely to
damage the electronics inside the radio if fully screwed in.
The D-Sub-Connector (plug) has to be clamped with both
spring locks. It is recommended to secure them additionally
with a cable tie.
