1
2
N N L
L1
N
Black
Blue
Yellow-Green
Motor
1
Receiver box
Centralis receiver RTS
1: EKK 3 G 1,5 mm²
2: EKK 4 G 1,5 mm²
G
Programming button
D
Up
E
Stop
F
Down
- The box shall be mounted with the cables entering and exiting
from the bottom of the box.
- The box shall not be mounted in a metal casing.
- All metal objects in the vicinity of the receiver will impair the
reception.
- The antenna is built-in.
- Minimum distance:Between floor/ground and receiver
150 cm
.
Between two receivers
20 cm
.
Mellan sändare och mottagare
30 cm
.
N.B.!
Only one motor must be connected to the Centralis box!
Receiver box:
Press the programming button,
B
, inside the receiver box approximately
2 seconds, until the indication lamp,
A
, starts to shine.
The receiver is now, during one minute, ready to receive the signals from
the transmitter.
Transmitter:
Press shortly the programming button of the transmitter,
G
.
The indication lamp in the receiver box then starts to twinkle, which shows
that the transmitter's signal is memorised and programmed.
Open the lid of the receiver box.
Receiver box:
Press the programming button,
B
,
inside the receiver box approximately
10 seconds until the indication lamp,
A
, starts to shine.
Installation
Receiver box
Transmitter
Cable drawing
Wire diagram
Programming of transmitter and receiver.
Delete programming.
L
N
N
Feeding live
Feeding neutral
Motor neutral
Motor up
Motor down
N L
A
Indication lamp
B
Programming button
C
Push button for
manual testing
L
N
Not in use
Not in use
Brown
Open the lid of the receiver box.
