IMPORTANT!
When using electrical equipment, including this emergency exit product, basic safety
precautions should be followed at all times, including but not limited to the following:
PLEASE READ CAREFULLY AND FOLLOW ALL INSTRUCTIONS FOR YOUR SAFETY
1.
Do not use outdoors.
2.
Equipment should be mounted in locations at heights where it will not be subject to tampering by
4.
The use of accessories not recommended by the manufacturer may cause an unsafe condition.
5.
Do not use this equipment for other than its intended use.
6.
Servicing of this equipment should be performed by qualified personnel.
Page 1 of 2
20
-
Rev A
17 725
Fulham Co. Inc.: 12705 South Van Ness Ave., Hawthorne, CA 90250 Tel.: 1-323-779-2980 Fax.: 1-323-754-9060.
Specifications subject to change without notice.
[email protected] www.fulham.com
3.
Do not mount near gas or electric heaters.
SAVE THESE INSTRUCTIONS
• For connection to branch circuit wiring, use only conduit and conduit fittings suitable for wet locations.
• Battery in this unit may not be fully charged.
• Disconnect AC power before servicing and installation
INSTALLATION (J-BOX Mounting)
GENERAL INSTALLATION
GUIDELINES FOR COMBINATION
EMERGENCY EXIT LIGHT
(FHEM10WHU)
7.
Disconnect AC power before servicing.
FLEXIBLE CONDUIT ONLY!
INSTALLATION (CONDUIT)
1) Secure back plate to wall surface . Route wires through hole in conduit flange and make conduit
connection.
2) Connect battery only after AC power can be provided to the unit (Fig. B).
3) Align snaps and push housing directly onto back plate (Fig. C). Supply AC power and press "TEST"
Battery in this unit may not be fully charged. After connecting unit to AC power, allow battery to
charge for at least 24 hours, before performing operational test . To perform operational test, press
the " TEST " button. The light on the unit should be illuminated. The lamps listed herein,when used
The lamps listed herein,when used according to these instructionsare in accordance with the
requirements of UL924 standards.
unauthorized personnel.
1) Feed fixture leads through back plate and connect AC power supply (Fig A).
2) Connect wires through J-Box. Secure back plate on to J-Box with screws.
3) Connect battery only after AC power can be provided to the unit (Fig. B).
4) Align snaps and push housing directly onto back plate (Fig. C). Supply AC power and press “TEST”
button to check light.