8
9
EN
FUNCTION
Switching the Touch Control ON/
OFF
After mains voltage is applied the
control initialises for approx. 1 second
before it is ready for operation. After
a reset all display and LEDs glow for
approx. 1 second. When this time is
over all displays and LEDs extinguish
and the control is in the stand-by mode.
By operating the ON/OFF key the
control can be turned into the ON-
mode. The cooking zone displays
shows a static "0".
If a cooking zone is in the "hot" status,
the display shows a static "H" instead
of "0". The bottom right dot is blinking in
1 second intervals on all cooking zone
display to indicate that no cooking zone
is selected at the moment.
After switching-ON the electronic control
remains activated for 20 seconds. If no
cooking zone or timer selection follows
within thi period of time, the electronic
control automatically switches back into
the stand-by-mode.
The control can only be switched-ON
if it identifies the ON/OFF key alone
being operated. Should it recognize key
activation other than that, the control
remains in the stand-by-mode.
If the child safety feature is active when
switching on, all cooking zone show "L"
(LOKED). (also refer to 1.9).
If the cooking zones are in a "hot"
status, the display shows "L" and "H" in
alternation.
When the Touch Control is ON it can be
switched-OFF at any time by operating
the ON/OFF key. This is also valid if the
control has been locked (activated child
safety feature).
The ON/OFF key has always priority in
the switch-OFF function.
Automatic switch-OFF
When the control is ON it automatically
switches-OFF after 20 seconds if no
cooking zone or select key has been
operated within this period of time.
If case of a cooking zone selection,
the automatic switch-OFF time is
composed of 10 seconds deselection
time for a cooking zone at setting"0"
and 10 seconds switch-OFF time.
Switching a cooking zone ON and
OFF
If the control is ON the respective
cooking zone can be selected by
operating a cooking-zone-select-key
(=PLUS-key of the respective cooking
zone). There is a static dot indication
in the respective display. If the cooking
zone is hot "0" is displayed instead of
"H" . On all other cooking zone displays
the blinking dot extinguishes. Then a
setting will be chosen by a renewed
operation of the cooking- zoneselect-
key or the MINUS-key and the cooking
zone begins to heat up. In order to
use the cooking-zone-select-key as a
PLUS-key the control has to recognize
that after the selection the cooking zone
has been released for 0,3 seconds.
After selection of a cooking zone the
setting can be increased by continously
pressing the PLUS-key, starting at step
"1" it is increased by 1 step every 0,4
