Fukuda VaSera VS-2000 Series, Operation Manual

Page: 92 / 234

5-2
Chapter 5 Blood Pressure and Pulse Wave Examinations (CAVI/ABI/TBI): Standard Mode
Measurement Preparations
Check the following again before measuring.
Two modes can be used for blood pressure and pulse wave examinations: Simple Examination Mode and Standard
Examination Mode. This section explains Standard Examination Mode.
The mode can be switched by configuring the setting in [Menu] - [Setting] - [Equipment Control] - [Examination Mode].
(Refer to "Equipment Control Settings" (P11-6) .)
Is the place of examination appropriate?
• Check for noise generating electrical devices such as x-ray equipment or ultrasonic instruments nearby.
If any, turn them OFF or change the place of examination to avoid adverse influence from such instruments.
• Select a location with low humidity.
• Make sure the selected location is quiet and not exposed to engine noise, noise from air conditioners, vibrations from
railroads, passing cars or treadmills.
How is the condition of the patient?
• Check if the patient is nervous.
If nervous, his/her blood pressure may be higher than normal. Reassure the patient by briefly explaining the examination
method to the patient.
• Also, instruct the patient not to move or speak.
Are the cuffs and sensors connected to the device and applied to the patient correctly?
• If not, it may not be possible to perform the examination or the results may be incorrect.
Is the air hose bent, or is there any object placed on the air hose?
• It may affect the accuracy of the examination and cause incorrect examination results.
Let the patient lie down and rest for 10 minutes or more before starting the measurements.