Fukuda DYASCOPE 8000 Series, Operation Manual, Page: 85 / 349

5-3
Chapter 5 Preparation Installing the Recording Paper (Optional)
Installing the Recording Paper (Optional)
When using the optional Recorder Unit (HR-800), install the paper using the following procedure.
CAUTION
 About the Recording Paper
 Use only "OP050-01TDR" for the recording paper.
If the surface treatment and thickness of the recording paper are different, it may result
in poor print quality.
 Storing the Recording Paper
Since the recording paper is thermal type, inappropriate storage may change the quality of
the printed content, and make it illegible.
When storing the recording paper, follow the precautions below.
 Store in a place where light is shut off and avoid direct sunlight.
 Do not leave the paper in a high temperature (50 °C/122 °F and above).
 Do not store the paper in a polyvinyl chloride bag.

Do not superpose the papers until the diazo copy is completely dried.
 Do not expose the paper to alcohol, hydrochloric acid, or ester ketone.
 Avoid using adhesive agents other than water based glue.
 Installing the Recording Paper

When installing the recording paper, pay attention not to touch the thermal head or
sensor. The temperature of those parts rises immediately after printing and may cause
burn injury. Also, it may cause failure to the thermal head and sensor.
 Do not operate the equipment with wet hand. Doing so may short the thermal head.
Install the recording paper with the following procedure.
1
Press the Open/Close Lever.