Fukuda DYASCOPE 8000 Series, Operation Manual

Page: 34 / 349

xiv
Safety Precautions about the Peripheral Device, Accessories, Optional Accessories
RTC and Data Backup

This equipment is equipped with a built-in clock. When the power of this equipment is turned OFF, this clock
is backed up by a lithium battery. If incorrect time is displayed when turning ON the power, a low battery may
be the cause. In such case, contact your nearest service representative for replacing the battery.
 To protect the data during voltage dip, short interruptions and voltage variations on power supply input lines
or during short duration of power turned OFF, this equipment performs 5-minute (approx.) data backup using
the secondary battery. If the power is turned OFF for more than 5 minutes, the data will not be protected. The
data may not be protected if the power is turned OFF within 30 minutes from power ON. The data that may not
be protected are NIBP list data, alarm history, and the data just before turning OFF the power for trend, recall,
full disclosure waveform.
 The set alarm limits on this equipment will be retained even after the power is turned OFF.
Cables
 When disconnecting the cables, pull on the connector and not on the cable itself. For cable with a lock tab, push
the tab when disconnecting. Pull the connector straight so the connector pins do not bend. When attaching the
cables to each other, both connectors should be directly facing each other.
Precautions about the Peripheral Device, Accessories, Optional Accessories
Connection to Peripheral Device
To use the equipment safely and to ensure maximum performance of the equipment, connection of other
manufacturer's equipment to this equipment is not authorized, unless the connection is explicitly approved by Fukuda
Denshi. It is the user's responsibility to contact Fukuda Denshi to determine the compatibility and warranty status of
any connection made to another manufacturer's equipment.
When connecting peripheral devices to this equipment, it is the user's responsibility to verify that the overall system
complies with "ES60601-1 Clause 16 "ME SYSTEMS"".
 For the connector with mark, only the peripheral devices specified by Fukuda Denshi should be connected
with the given procedure. Use of an unspecified device may cause electric shock to the patient and/or operator
due to excessive leakage current.
Fuse
 If the fuse blows, contact Fukuda Denshi service representative. Do not continue using it as internal damage to
the equipment may be considered.
CAUTION
CAUTION
WARNING
DANGER