Fukuda DYASCOPE 8000 Series, Operation Manual

Page: 32 / 349

xii
Safety Precautions for Using the Equipment
 If "Suspend Arrhy. Analysis during Noise Interference" ("Initial Settings" > [Alarm Setup]) is set to [ON], the
"Cannot analyze" alarm will generate when analysis is suspended for 30 seconds and longer.
 Depending on the bedside monitor type and software version, BP7, BP8, TEMP3–8, SpMet, SpCO, SpHb
alarm will not be generated on the central monitor.
 If the same or similar equipments with different alarm settings are used in the same facility or same department,
pay attention not to misjudge the alarms.
Precautions about the PHS Nurse Call System
 When connecting multiple central monitors to one nurse call system, LAN adapter is required. When using the
LAN adapter, contact your nearest service representative.
 Perform nurse call daily check and make sure that alarm is properly notified to the nurse call system.
Precautions about the TCP/IP Network
 Make sure to power cycle the printer after setting the IP address, etc. for the laser printer.
Precautions about the Maintenance

When cleaning the touch panel, never use strong-acidic cleaning solution.
 To clean the touch panel, use an optional cleaning cloth, eyeglass cleaning cloth, soft cotton cloth, or non-
woven cloth (pulp, rayon, polyethylene, etc.).
 Clean the equipment frequently so stains can be removed easily.

To prevent injury, it is recommended to wear gloves when cleaning the equipment.
 Pay attention not to allow chemical solution to enter the equipment or connectors.

Do not use organic solvents, thinner, toluene or benzene to avoid damaging the resin case.
 Do not polish the equipment with abrasive or chemical cleaner.

When disinfecting the entire room using a spray solution, pay close attention not to get any solution into the
equipment or connectors.

Use only neutral detergent to clean the equipment. The surface resin coating may damage, resulting in
discoloration, scratches, and malfunction.
Example:
chemical cloth, scrub brush, abrasive, polishing powder, hot water, volatile solvent and chemicals (cleanser,
thinner, benzine, benzol, and synthetic detergent for house and furniture), or sharp-edged tools
 Do not open the housing.

Do not allow alcohol or other liquids to enter the equipment.
 Replace the periodic replacement parts periodically as specified.
Wired Network System
 Do not connect unspecified equipment to the wired network.

This equipment cannot connect to the DS-LANII network.
 For the DS-LANIII network, use the specified HUB. If unspecified HUB is used, a communication error may
occur.

The DS-5000 series bedside monitors, LW-5500N Telemetry Receiver, and AU-5500N 8ch Recorder are not
compatible with the DS-LANIII network.

The central monitor with the Central ID, "001" will function as a network-administrating monitor, and controls
the whole LAN system. One of the central monitors must have the Central ID, "001" in a network system. Also,
make sure not to duplicate the Central ID with other monitors.
CAUTION
CAUTION
CAUTION
WARNING
CAUTION