Fukuda DYASCOPE 8000 Series, Operation Manual, Page: 226 / 349

12-14
Chapter 12 Printing Measurement Status
It will stack a new data instead.
Measurement Status
Measurement status such as vital signal condition and equipment status will be printed after the printing type.
The following measurement status will be printed.
Measurement Status Description
LEAD OFF The electrode is detached. Check electrodes.
CVA CVA is detected.
P SEARCH SpO
2
pulse wave is small.
SpO
2
probe sensor attachment is not appropriate, etc.
ECG LOW The amplitude of ECG waveform is too low.
ECG CAN'T Cannot analyze
ECG1 LOW The amplitude of ECG1 waveform is low.
ECG2 LOW The amplitude of ECG2 waveform is low.
ECG1 CAN'T Cannot perform arrhythmia analysis of ECG1.
ECG2 CAN'T Cannot perform arrhythmia analysis of ECG2.
CO
2
CHECK CO
2
sensor error.
TLM OFF Too far, noise interference.
TLM LOWBAT Telemetry battery or bedside monitor battery is depleted.
LAN OFF Communication error with DS-LANIII.
DS-LANIII connection is cut off.
Cannot receive data via DS-LANIII.
TCON OFF TCON signal cannot be received.
Data cannot be received by TCON.
TCON ERROR Communication error with TCON.
CHECK SPIRO SPIRO unit is malfunctioning.