Fukuda DYASCOPE 8000 Series, Operation Manual, Page: 181 / 349

9-15
Chapter 9 Data Review Recall
8
Deleting the Displayed Recall Enlarged Waveform
 Pressing the [Delete] key will display the [Delete OK]/[Cancel] keys.
 Press the [Delete OK] key to delete the displayed enlarged waveform.
9
Printing the Recall Waveform
 The displayed enlarged waveform and numeric data will be printed. The output printer can be selected on
the "Print Settings".
(

"Output Printer Setup for Review Data Printing" P12-9)
10
Divider Function
(

"Divider Function" P9-15)
Divider Function
By using the divider function, PR, RR, PP interval of ECG can be measured.
NOTE
 The divider function can be used only when a mouse is connected.
1
The divider mode will be activated by dragging the mouse to the right on the enlarged waveform.
2
Divider Mode Operation
1
The divider start line will be displayed on
the dragging start point.
2
While dragging the mouse to the right,
the divider end line will be displayed
along with the mouse pointer.
3
When the drag operation is released, the
finalized divider end line will be displayed.
 The divider interval will be displayed in "mm" unit.
 [Multiple], [Cancel] key will be displayed in the waveform area.
 Square marks will be displayed at upper end/lower end/center of the divider start line and end line.
The divider lines can be adjusted using these marks.
4
To adjust the divider lines after they are finalized, use the square marks on
the divider lines.
 By using the square marks on the upper/lower end (*1 shown on right),
the divider line can be dragged.
 By using the square marks on the center (*2 shown on right), the start
line and end line can be dragged at the same time without changing the
1
4
3
*1
*1
*2