Fukuda DYASCOPE 8000 Series, Operation Manual, Page: 103 / 349

6-13
Chapter 6 Admit/Discharge Suspend Monitoring
Suspend Monitoring
This section explains the procedure to suspend and resume monitoring when a patient temporarily leaves the bed.
With this suspend monitoring function, data measurement, alarm generation, automatic measurement, and automatic
printing can be suspended without erasing any data and setup condition.
By using the monitor suspend label function, different labels in different colors according to the patient's destination
can be displayed during the monitoring suspended condition.
To remind the user to resume monitoring, alarm will generate after the preprogrammed duration (15 min./30 min./1
hr/1.5 hr/2 hr) for "Monitor Suspend Timer".
By selecting [ON] for "Auto Resume Monitoring", the monitoring will automatically start under the specified
condition. (

"Condition for Auto Resume Monitoring" P6-16)
CAUTION
 During the monitoring suspended condition, the trend data and full disclosure waveform data
will not be acquired.
 Resuming monitoring will also resume the suspended alarm.

Depending on the model type and software version of the bedside monitor, the monitor
suspend/resume operation will not synchronize between the bedside monitor and the central
monitor.
 Suspending/resuming monitoring on the bedside monitor will not suspend/resume
monitoring on the central monitor.
 Similarly, suspending/resuming monitoring on the central monitor will not suspend/
resume monitoring on the bedside monitor.
 If monitoring is suspended on the bedside monitor, the data for that patient will not be
displayed on the central monitor. If monitoring is resumed on the bedside monitor, the
data for that patient will be displayed again on the central monitor.
 The monitor suspend/resume operation on the bedside monitor can be synchronized to the
central monitor, but the monitor suspend operation on the central monitor cannot be
synchronized to the bedside monitor.
 For details of the bedside monitor which is compatible to synchronizing the monitor suspend
operation, contact your nearest service representative.
 When the monitoring is resumed, make sure that the monitoring is also resumed on the
central monitor.
REFERENCE
 To display the detailed message during monitoring suspended condition, select ON for
"Monitor Suspend's Message Selection", and set the details under [Menu] > [Monitor
Suspend] ("Common Setup"). (

"Monitor Suspend Setup" P13-38)