Fukuda Denshi HS-8000 Series, Service Manual

Page: 7 / 132

Precautions for Safe Operation of Medical Electrical Equipment
C A U T I O N
Read the following precautions thoroughly to correctly operate the device.
z Users should have a thorough knowledge of the operation before using
this system.
z Pay attention to the following when installing and storing the equipment.
y Do not install or store in an area where the equipment will be subject to
splashing water.
y Do not install or store in an area where the environmental conditions, such as
atmospheric pressure, temperature, humidity, ventilation, sunlight, dust, sodium,
sulfur, will adversely affect the system.
y Place the equipment on a stable surface where there is no inclination, vibration,
or shock (including during transportation).
y Do not install or store in an area where there are chemical or gasses stored.
z Before operating the system, verify the following items.
y Verify the power voltage.
y Check the cable connection to ensure proper operation of the unit.
y Ensure that all cables are firmly and safely connected.
y Pay special attention when the device is used in conjunction with other
equipment as it may cause erroneous judgment and danger.
y Ensure all patient connections are proper and secure.
z During operation of the system, verify the following items.
y Always observe the system and patient to ensure safe operation of the
equipment.
y If any abnormality is found on the equipment or patient, take appropriate
measures such as ceasing operation of the equipment in the safest way for the
patient.
y Do not allow the patient to come in contact with the device.
z After using the system, verify the following items.
y Unplug all the cables from the patient before turning off the power.
y When unplugging the cables, do not apply excessive force by pulling on the
cable. Pull by the connector part of the cable.
y Clean the accessories and cables, and keep them together in one place.
y Keep the unit clean to ensure proper operation of the next use.
z Do not remodel the equipment.
z Maintenance Check
y
Make sure to periodically check the equipment, accessories and cables.
y Before reusing the device that has been left unused for a while, make sure that
the device works normally and safely.
z To prevent burn injury to the patient, verify proper attachment of patient
ground plate or ECG electrode type when using the electrosurgical knife,
and verify paste volume or output energy when using the defibrillator. Also,
verify that proper ground is selected.
iii