Fukuda Denshi Dynascope 8000 Series, Maintenance Manual

Page: 76 / 154

4-6
Chapter 4 Connection to the External Devices Setup for the External Device Connection
NOTE

The BIS monitor cannot be set to multiple ports. If the setting is duplicated, the other
port will be automatically set to [OFF].

The "AC Unit" setup menu will be displayed only if AC Unit (DSA-81) is connected to
the DS-8007. When performing the "AC Unit" setup, make sure to connect the AC Unit
(DSA-81) to the DS-8007.

When using the BISx, BIS Monitor data cannot be input.
Setup for the External Device Connection
This section explains about the external device connection setup.
External Device Setup
1
Press the [Menu], [Setup], [Initial Settings], [External Device] keys.

The "External Device" setup menu will be displayed.
1 Select the connecting port from the left side of the
screen.
2 Select the connecting equipment from the displayed
selection.
By selecting a category ([Vent.] or [Other]) from the
upper area, the corresponding selection for each
category will be displayed at the lower area.
NOTE

The same function cannot be set to multiple ports.

When [Magnetic Card Reader] is selected, perform further settings on the "Magnetic Card
Reader" setup menu.

The "AC Unit" setup menu will be displayed only if AC Unit (DSA-81) is connected to the DS-
8007. When performing the "AC Unit" setup, make sure to connect the AC Unit (DSA-81) to
the DS-8007.

On the DS-8007 system, the Status II connector and serial connector (COM) settings are
saved on the AC Unit (DSA-81).
Selectable External Device for Each Port
Port Selectable External Device
COM PC Comm., Barcode Reader, Magnetic Card Reader, BIS, PC (DS-5000)
Status II SV-300, SERVO i/s, PB, Evita, BIS, SERVO-U/n/air, Velia, Ultra, Astral
1
2