Fukuda Denshi Dynascope 8000 Series, Maintenance Manual

Page: 41 / 154

1-1
Chapter 1 Installation of the Unit Precautions for Installing the Equipment
Chapter 1 Installation of the Unit
Precautions for Installing the Equipment
This section describes the environmental condition to use this equipment.
CAUTION

The installation of this equipment should be performed by our service representative or a
person who is well acquainted with this equipment.

Avoid stacking multiple equipments or placing anything on the equipment during operation.

Install this equipment in a place where power supply cable can be easily disconnected.

If any abnormality is found on the equipment, immediately turn OFF the power, and
disconnect the power supply cable from the outlet.

Do not soak or immerse the equipment in liquids.
Operating Environment

The following environmental conditions should be observed when operating the equipment.

Surrounding Temperature: 10
°
C to 40
°
C

Relative Humidity: 30% to 85% (non-condensing)

Atmospheric Pressure : 70 kPa to 106 kPa

This equipment is intended for patient monitoring in NICU, ICU, CCU, surgery, emergency room and ward.
Do not use in MRI environment or in a home-care setting.

The power source should fulfill the following condition.

Use a hospital grade outlet (3-pin grounded outlet).

Verify power voltage and frequency before connecting to an AC power source.

Use the power source that can provide adequate power to the device.
Refer

Operation Manual "Main Unit: DS-8007" P14-1 for power voltage, frequency, and power
consumption.

Pay attention to install or store the equipment in proper location. Do not install or store in the following
locations.

where chemicals are stored or gas may generate

where the equipment will be subject to splashing water or humidity from a nebulizer or vaporizer

where the equipment will be subject to direct sunlight

where the equipment will be subject to inclination, vibration, or shock.

Ensure proper ventilation to cool the device.

A minimum space of 5 cm is required between the rear side of the monitor and the wall.If the monitor is
embedded in a wall or surrounded by a wall, a minimum space of 10 cm is required.