Fukuda Denshi DynaScope 7000 Series, Service Manual

Page: 63 / 143

Connection with Other Devices
Connection with a Slave Monitor
A slave monitor can be connected to the DS-7000.
The specified XGA slave monitor equipped with analog RGB interface can be connected. *
1
Standard analog RGB video cable can be also used.
As the picture resolution of the slave monitor will be the same as the DS-7000 touch panel display
(XGA 1024
×
768 pixel), verify that the appropriate resolution can be displayed on the slave monitor.
*
2
*
1
When connecting the slave monitor, use an isolation transformer as the slave monitor output is
not isolated.
*
2
When lower resolution XGA is displayed on the higher resolution SXGA slave monitor, the
display may be small at the center of the screen or displayed unclear depending on the
presence of conversion circuit and performance.
3
－
7