Fukuda Denshi DynaScope 7000 Series, Operation Manual

Page: 379 / 475

Remote Control Setup
Assign a function to the 8 user keys on the remote control unit.
1
Press the Menu → Initial Settings → Remote Control keys.
The remote control unit setup menu will be displayed.
2
Set the remote control monitor ID.
Set the bed ID which will respond to the monitor selection dial on the remote control unit.
Select the monitor ID from 1 to 8 .
Select R.C. OFF if not using the remote control
function.
9
3
Select the key location.
Select the key location of the remote control unit to
change or assign a function.
F1 F2 F3
F4 F5 F6
F7 F8
Key Location on the Remote Control Unit
The “F1” key on the remote control unit is the same key
as the “1” key on the remote control setup menu.
Rem
ote Co
ntrol Setup
4
Select a function.
Select a function to be assigned for the selected key
location.
Pressing the function key will assign the function to the
selected key location.
Use the 1/2 , 2/2 keys to switch the page for
function selection.
9 － 19