Fukuda Denshi DynaScope 7000 Series, Operation Manual

Page: 228 / 475

6 － 80
C A U T I O N
There are 2 types of DRYLINE™ Water Traps for Adult/Pediatric, and
Neonate and selectable follow rate depends on the water trap type.
Depending on the patient, select appropriate Water Trap.
●
Wave Clip
If the gas waveform exceeds the waveform display area, whether or not to clip the exceeded part can
be selected.
ON will display the exceeded part of the waveform in
straight line.
OFF will display the whole part of waveform even if it
exceeds the display area. However, the exceeded part
may not be displayed depending on the sweep speed of
the waveform displayed above or below the gas
waveform.
●
GAS Display during Undetected Breath
Gas data display when a respiration is not detected can be selected from Invalid (bar display) or
Insp. Only (displays only the inspiratory data).
Invalid will make the inspiratory and expiratory data
invalid when a respiration is not detected and bar marks
will be displayed instead.
Insp. Only will make only the inspiratory data valid
when a respiration is not detected, and bar marks will
be displayed for expiratory data.
N O T E
When [Insp. Only] is selected for “GAS Display during Undetected Breath” and if only
inspiratory data is displayed, inspiratory and expiratory data display on the central
monitor will become invalid.
●
Manual Zero Calibration
On the patient monitor, a zero calibration for the multigas measurement is periodically performed.
However, it is possible to perform a zero calibration when necessary.
Press the Start zeroing key to start the zero
calibration manually.
In calibration progress, the “Zeroing in Progress”
message will be displayed.
When the calibration is completed, the “Zeroing
Complete” message will be displayed.