6
-
78
Anesthetic Gas Label
The anesthetic gas label can be selected on the AGT setup menu.
Select the label from ISO , SEV , HAL , ENF , DES .
If Auto is selected, the label will be automatically set
according to the detected anesthetic gas.
If the multigas unit detects a different anesthetic gas type from
the set label, the alarm sound will generate, and “Agent
∗∗∗
?”
(
∗∗∗
: anesthetics gas label) message will be displayed.
N O T E
In case of the MGU-801P/MGU-802, the Auto , ISO , SEV , HAL , ENF ,
and DES keys for AGT Label setup will not appear. The label will be automatically
set according to the detected anesthetic gas.
GAS Setup (MGU-701/MGU-702/Poet IQ)
The GAS setup menu can be accessed by pressing the GAS Setup key.
●
ON/OFF of Gas Measurement
Select ON or OFF for “Gas Measurement”.
ON will perform gas measurement.
OFF will not perform gas measurement.
●
Flow Rate
Select the “Flow Rate” from 100 / 150 / 200 mL/min.
●
Wave Clip
If the gas waveform exceeds the waveform display area, whether or not to clip the exceeded part can
be selected.
ON will display the exceeded part of the waveform in straight
line.
OFF will display the whole part of waveform even if it
exceeds the display area. However, the exceeded part may not
be displayed depending on the sweep speed of the waveform
displayed above or below the gas waveform.
Summary of Contents for DynaScope 7000 Series
