Fukuda Denshi DynaScope 7000 Series, Operation Manual

Page: 178 / 475

6 － 30
BP Alarm
1
Press the BP Alarm key.
The BP alarm setup menu will be displayed.
Select ON/OFF for BP alarm and set the upper and lower
alarm limit for systolic (S), diastolic (D), and mean (M) BP.
The alarm value is to be set for each measurement unit. (mmHg / kPa)
The adjustable increment for upper and lower limit changes from 50mmHg / 7kPa.
mmHg : 0 to 50mmHg / 2mmHg increment
55 to 300mmHg / 5mmHg increment
kPa : 0 to 7kPa / 0.2kPa increment
7.5 to 40.0kPa / 0.5kPa increment
Key Item Description
Individual Alarm
Selecting ON will generate BP alarm.
Selecting OFF will not generate BP alarm.
▲
Current Value Indicates the current value.
Select from S (systolic BP), D (diastolic BP), M (mean
BP).
Lower Alarm Limit
Sets the lower alarm limit (0 to 295mmHg / 0 to
39.5kPa).
Setting the value equal to or below 0mmHg / 0kPa will
turn OFF the alarm.
Upper Alarm Limit
Set the upper limit (2 to 300 mmHg / 0.2 to 40.0kPa).
Setting the value equal to or above 300 mmHg / 40.0kPa
will turn OFF the alarm.
Automatic Setup
When the BP label is BP1/ART, the upper and lower limit
will be automatically set to +40mmHg / +5kPa and
–20mmHg / –3kPa respectively from the current value.
When the BP label is other than BP1/ART, the upper
and lower limit will be automatically set to the current
value +20%, –20% respectively from the current value.
To maintain the alarm setting even after the power is turned OFF or after the discharge procedure,
store the setting to one of the alarm modes, or select ON for “Backup at Discharge” on the
Discharge Mode setup menu under the Initial Settings.
Reference
For the alarm mode setup procedure, refer to “9. Initial Settings –Alarm Mode Setup–”.