Fukuda Denshi DS-7001, Service Manual

Page: 74 / 151

DIP Switch
This section explains about the DIP switch located at the rear side of the equipment.
CAUTION
Only service engineers are allowed to change the DIP switch setting.
After changing the DIP switch setting, be sure to attach the rear cover
so that the users will not be able to easily access the DIP switch.
After the necessary procedure, be sure to set the DIP switch back to
default setting.
DIP Switch Setting
For normal usage, the change in DIP switch setting is not necessary. Do not change the DIP
switch setting unless required.
The change in DIP switch setting is required when displaying the maintenance menu or when
performing the forced install process. After the procedure, make sure to set the DIP switch
back to default setting.
Refer following for the function of each DIP switch.
SW No. Default Description (When ON)
1 OFF
Test menu key display
If the system is started with No. 1 set to ON, the system will be
initialized to factory default setting.
2 ON
Display mode for export use
Telemetry channel mode for CE
3 OFF Not used. (Reserved Function)
4 OFF Not used. (Reserved Function)
5 OFF
If No. 5 and 6 is set to ON, pressure sensor 2 measurement will be
also displayed on the measurement test mode.
(used only for factory inspection)
6 OFF Measurement test mode (used only for factory inspection)
7 OFF
Technology conformance test mode
(used only for factory inspection)
8 OFF Forced Installing
CAUTION
For normal usage, it is not necessary to change the DIP switch
setting. Use the equipment with the default DIP switch setting.
If the equipment is used with incorrect DIP switch setting, the following
malfunction may occur.
Ÿ
Ÿ
Ÿ
Ÿ
Initializing of patient data, setup data
Changing of displayed language
Telemetry error
Measurement inability
4 － 12