Fukuda Denshi DS-7001, Service Manual

Page: 102 / 151

CF Function Setup
CF
The hard copy of the displayed screen can be recorded on the CF card using this function.
CAUTION
The ”NIBP Start/Stop” key is used for the hard copy function.
When ”Hard Copy” is set to ON, the manual NIBP measurement
cannot be performed. After using the hard copy function, make sure
to set the “Hard Copy” to OFF, and check that manual NIBP
measurement can be properly performed.
Hard Copy
By setting the hard copy function to ON, the hard copy of the displayed screen can be recorded
on the CF card in bitmap format. Maximum of 8 screens can be recorded. The recorded
screen can be viewed on the Windows 98/Me/2000.
※
The Windows2000 is compatible with the DS-7001 with the version V4-1 and newer.
1 Select ON for “Hard Copy” on the “CF” menu.
2 Insert the CF card formatted on the DS-7001 to the CF card slot.
3 Display the screen to copy, and press the “NIBP Start/Stop” key.
4 During recording, a small sound will be generated. When a medium sound is
generated, the recording is complete.
5 Remove the CF card, and verify the recorded screen on the compatible PC.
6 Set the “Hard Copy” to OFF, and check that the manual NIBP measurement can
be properly performed.
Rec 1min
This is used for debug.
5 － 24