Fujitsu XG2000R, Hardware Manual

Page: 63 / 75

Cable Connection
61
2
The cables need to be connected to the XG2000R XFP modules.
1.
Connect the fiber optic cables to the XG2000R.
Connect the fiber optic cables to the XFP modules (Port 1 - Port 20) on the front of XG2000R.
CAUTION
A fiber optic connector is used when connecting two fiber optic cables. When con-
nectors such as these are used, it is important that they be connected correctly.
If a connector is misconnected, or cleaned incorrectly, it can be damaged. If the fiber
optic connector is dirty or damaged, data transmission may become error prone and/
or unstable.
Attention Attention
• It is necessary that the connectors be fixed in the correct position in order to
protect the connector interface against foreign objects such as dust.
• When a fibre connector is not clean or not fit snugly, it may not communicate - not
link -. Unclean optic fibre connectors may result in optical loss therefore please
keep it clean. When connectors are not used, protect them by dust covers from
adhesion of dirt. Dust cover is not offered from us.
• Use alcohol pads for dirty optic fibre connections.
After connecting the peripheral units, connect the XG2000R power cords.
Refer to "For Safe Use of the XG2000R (P.2)".
2-4
Cable Connection
This section explains how to connect the cables and power cords.
2-4-1 Connecting cables
Port 2
Port 1
Port 6
Port 5
Port 10
Port 9
Port 14
Port 13
Port 18
Port 17
Port 4
Port 3
Port 8
Port 7
Port 12
Port 11
Port 16
Port 15
Port 20
Port 19
2-4-2 Connecting the power cords