64
Installation and Operation
WARNING
• When removing a power plug from its outlet, be sure to pull on the power plug on.
Pulling on the power cord may expose the wires or break the cord, and cause elec-
tric shock or fire.
• In case of strange heat, smoke, and/or a strange smell are emitted from the
XG2000CR, immediately disconnect the power cord from the AC outlet. To make
this easy, set the XG2000CR nearby the AC outlet, and keep it within the reach of
the power cord for pulling it easily. After the power is disconnected, contact the
vendor's service department immediately. Continued use of the XG2000CR may
cause an electric shock and fire. Note that in this case, the state of data in trans-
mission is not guaranteed.
1.
Execute the "system shutdown" command.
Confirm the firmware update is not in progress, then execute "system shutdown" from the
CLI.
When XG2000CR is shutdown, the Alarm LED at the front turns on and the Power Supply
LED at the rear blinks green.
2.
Disconnect the two AC power cords from the AC outlet.
2-5-2 Turning off the XG2000CR
Refer
Refer
For details of the system shutdown command, refer to the "Command Reference" section in
the "XG2000 series User's Guide".
Refer
Refer