Fujitsu SPARC M10-4, Service Manual

Page: 360 / 514

Note - Place the removed XSCF interface unit on a grounded antistatic ESD mat.
Note -
When mounting an XSCF interface unit, check the connectors on both of the
chassis and XSCF interface unit beforehand to confirm that no pin is bent and all the
pins are neatly arranged in lines. If an XSCF interface unit is mounted with a bent pin
in a connector, the chassis or XSCF interface unit may be damaged. Also, carefully
proceed with the work to prevent any pin from being bent.
Note -
Reinstall the cables in their original positions by referring to the notes that you made
before the start of maintenance.
Note - Ensure that the cables are firmly connected and secured.
20.5 Installing the XSCF Interface Unit
This section describes the procedure for installing the XSCF interface unit.
1.
Support the XSCF interface unit from below with one hand and then carefully
insert it into the chassis.
2.
Raise the right and left levers and tighten the two screws.
3.
Connect all the cables to the XSCF interface unit.
20.6 Restoring the System
This section describes the procedure for restoring the system after installing an XSCF
interface unit.
1.
Turn on the CB switches of the dedicated power distribution unit (PDU)
mounted on the rack for expanded connection.
Open the rear door of the rack, and push in all the CB switches on the PDU.
Electricity is supplied when the switches stay pushed in.
2.
Start the entire system.
For details, see " 6.4 Starting the Entire System ."
3.
Close the rack door.
Fujitsu M10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual
･
February 2014 336