Fujitsu SPARC M10-4, Service Manual

Page: 279 / 514

Caution -
Before you handle any components, wear a wrist strap to ground any static
electricity. If you perform this procedure without a wrist strap, individual
components or the overall system may be damaged. For details, see " 1.5 Notes
Regarding Static Electricity ."
Note - If the crossbar cables are fixed to the cable support with the hook-and-loop fastener,
remove the hook-and-loop fastener.
Note -
Record the positions of the cables before removing them to ensure that they are
reinstalled correctly.
B
A
B
A
Type-1 Type-2
13.5.1 Accessing a PCI Express card cassette
1.
Lower the cable support.
For details, see " 5.5.1 Lowering the cable support ."
2.
Remove the cables connected to the PCIe card cassette requiring maintenance.
13.5.2 Removing a PCI Express card cassette
There are two types of PCIe card cassettes. The shapes of the latch (A in the figure)
and lever (B in the figure) vary depending on the type of the PCIe card cassette, but
the same removal procedure applies. For the types of PCIe card cassettes, see "."
Unless otherwise specified, the figures explained in this section use Type-1.
Figure 13-3 Types of PCIe card cassettes
1.
Lower the lever (B in the figure) of the PCIe card cassette while pushing the
Chapter 13 Maintaining the PCI Express Cards 255