Fujitsu SPARC M10-4, Service Manual

Page: 257 / 514

#
cfgadm -c unconfigure Ap_ID
# cfgadm -x led=fault,mode=blink Ap_ID
#
cfgadm -a
Note - Use the DR of the system board on a physical partition for active/cold maintenance.
For the XCP and Oracle VM Server for SPARC/SRU versions that correspond to the DR, see
the latest Product Notes .
Note -
Active/hot maintenance (using DR) can be performed only for a building block
configuration.
XSCF>
showlogs error
6.
Execute the cfgadm(1M) command to blink the CHECK LED of the internal
disk requiring maintenance, and determine its location.
Enter the Ap_ID you noted in advance.
7.
Execute the cfgadm(1M) command to confirm that the internal disk requiring
maintenance is disconnected.
The disconnected internal disk is displayed as "unconfigured."
12.3.2 Active/hot maintenance (with DR)
1.
Open the rack door.
2.
Log in to the XSCF shell.
3.
Execute the showlogs command to identify the component requiring
maintenance.
For details, see " 3.3.5 Checking log information ."
4.
Confirm the hardware and software configurations.
For details, see " 4.2 Confirming the System Configuration ."
5.
Release the chassis, in which the internal disk requiring maintenance is
mounted, from the physical partition.
For details, see " 5.2 Releasing a Chassis from the Physical Partition ."
Chapter 12 Maintaining the Internal Disks 233