Fujitsu SPARC M10-1, Service Manual

Page: 192 / 230

Caution -
To completely shut down the system, all the power cords must be
removed. If the power cords are not removed, an electrical failure may occur.
XSCF>
showlogs error
Note - In the case of a dual power feed, make a note of the positions of the power cords
before removing them to ensure that they are reinstalled correctly.
Caution -
Before you handle any components, wear a wrist strap to ground any static
electricity. If you perform this procedure without a wrist strap, individual
components or the overall system may be damaged. For details, see " 1.4 Notes on
Static Electricity ."
1.
Open the rack door.
2.
Log in to the XSCF shell.
3.
Execute the showlogs command to identify the cable kit requiring maintenance.
For details, see " 3.3.5 Checking log information ."
4.
Confirm the hardware and software configurations.
For details, see " 4.2 Confirming the System Configuration ."
5.
Stop the system.
For details, see " 5.2 Stopping the System ."
6.
Remove all the power cords from the power supply unit.
For details, see " 5.3.1 Removing the power cords ."
16.4 Removing the Cable Kit
This section describes the procedure for removing the cable kit.
Enable removal of the cable kit before attempting to remove it. For details, see " 16.3
Enabling the Removal of the Cable Kit ."
16.4.1 Accessing the cable kit
1.
Remove all the power supply units.
For details, see " 9.4 Removing a Power Supply Unit ."
2.
Pull the chassis out of the rack.
For details, see " 5.3.2 Pulling the chassis out from the rack ."
Fujitsu M10-1/SPARC M10-1 Service Manual
･
November 2014 176