Fujitsu SPARC M10-1, Service Manual

Page: 149 / 230

Caution -
Before you handle any components, wear a wrist strap to ground any static
electricity. If you perform this procedure without a wrist strap, individual
components or the overall system may be damaged. For details, see " 1.4 Notes on
Static Electricity ."
Note - Record the positions of the cables before removing them to ensure that they are
reinstalled correctly.
Note - Place the removed PCIe riser on the grounded antistatic ESD mat.
12.4 Removing a PCI Express Card
This section describes the procedure for removing a PCIe card. Perform reduction
using the same procedure.
To expand a PCIe card, remove the PCIe card filler instead of the PCIe card.
Enable removal of the PCIe card before attempting to remove it. For details, see " 12.3
Enabling the Removal of a PCI Express Card ."
12.4.1 Accessing a PCIe card
1.
Disconnect all the cables connected to the PCIe card requiring maintenance.
2.
Pull the chassis out of the rack.
For details, see " 5.3.2 Pulling the chassis out from the rack ."
3.
Open the fan cover.
For details, see " 5.3.3 Opening the fan cover ."
4.
Remove the upper cover.
For details, see " 5.3.4 Removing the upper cover ."
12.4.2 Removing a PCI Express riser
1.
Hold the PCIe riser at two points and remove it.
Chapter 12 Maintaining the PCI Express Cards 133