Fujitsu SPARC M10-1, Service Manual

Page: 127 / 230

XSCF>
showlogs error
Note -
In the case of a dual power feed, make a note of the positions of the power cords
before removing them to ensure that they are reinstalled correctly.
Caution -
Before you handle any components, wear a wrist strap to ground any static
electricity. If you perform this procedure without a wrist strap, individual
components or the overall system may be damaged. For details, see " 1.4 Notes on
Static Electricity ."
4.
Confirm the hardware and software configurations.
For details, see " 4.2 Confirming the System Configuration ."
5.
Stop the system.
For details, see " 5.2 Stopping the System ."
10.3.3 Inactive/cold maintenance (system stopped/cold
maintenance)
1.
Open the rack door.
2.
Log in to the XSCF shell.
3.
Execute the showlogs command to identify the fan unit requiring maintenance.
For details, see " 3.3.5 Checking log information ."
4.
Confirm the hardware and software configurations.
For details, see " 4.2 Confirming the System Configuration ."
5.
Stop the system.
For details, see " 5.2 Stopping the System ."
6.
Remove all the power cords from the power supply unit.
For details, see " 5.3.1 Removing the power cords ."
10.4 Removing a Fan Unit
This section describes the procedure for removing a fan unit.
Enable the removal of a fan unit before attempting to remove it. For details, see " 10.3
Enabling the Removal of a Fan Unit ."
Chapter 10 Maintaining the Fan Units 111