Fujitsu SPARC Enterprise T5440 Server, Service Manual

Page: 76 / 214

50 SPARC Enterprise T5440 Server Service Manual • July 2009
▼
Clear Faults Detected in the External I/O
Expansion Unit
For service processor detected faults in the External I/O Expansion Unit, the fault
must be manually cleared from ILOM
show faulty
after the problem has been
repaired.
Note –
After the problem has been repaired, the fault will also be cleared from the
ILOM
show faulty
command by resetting the service processor.
The example below shows a problem detected in the External I/O Expansion Unit:
●
After the problem is repaired, use the ILOM
set clear_fault_action
command to clear a fault in the External I/O Expansion Unit.
Disabling Faulty Components
You can use the Automatic System Recovery (ASR) feature to configure the server to
automatically disable failed components until they can be replaced. The following
components are managed by the ASR feature:
■
UltraSPARC T2 Plus processor strands
■
Memory FB-DIMMs
-> show faulty
Target | Property | Value
--------------------+------------------------+-------------------
-------------
/SP/faultmgmt/0 | fru | /SYS/IOX@X0TC/IOB1/LINK
/SP/faultmgmt/0 | timestamp | Feb 05 18:28:20
/SP/faultmgmt/0/ | timestamp | Feb 05 18:28:20
faults/0 | |
/SP/faultmgmt/0/ | sp_detected_fault | Ext FRU
/SYS/IOX@X0TC/IOB1/LINK
faults/0 | | SIGCON=0 I2C no
device response
-> set clear_fault_action=true /SYS/IOX@X0TC/IOB1/LINK
Are you sure you want to clear /SYS/IOX@X0TC/IOB1/LINK (y/n)? y
Set ’clear_fault_action’ to ’true’