Fujitsu SPARC Enterprise T5140, Product Notes

Page: 53 / 138

Chapter 3 Known Issues 43
The
prtdiag
Command Doesn't Show the Correct
Memory Configuration in the Output, in the
Configuration with Different Memory Capacities (CR
6842745)
The
prtdiag
command doesn't show the correct memory configuration in the output, in the
following memory configuration:
It shows the memory size (48928 Megabytes) correctly.
Output example:
n/a In the environment where the Cisco Catalyst switch
series manufactured by Cisco Systems are connected
with the ILOM network management port (NET-
MGT), when you execute the switching restart or the
enable/disable operation of the network port, the
Cisco Catalyst switch and the ILOM network port
LEDs may not turn on, and the network linkup fails.
Due to this, access to ILOM using protocols such as
SSH (Secure Shell) fails. Use the Cisco IOS software 12.2(53)SG / 12.2(46)SE
version or later.
In case that the 12.2(53)SG / 12.2(46)SE version or
later cannot be applied, you can install other
hub/switch between the Cisco Catalyst switch and the
ALOM/ILOM network management port to avoid
this event.
It is already confirmed that this event can be avoided
using the switching hub manufactured by Fujitsu.
Perform the ILOM reset operation.
CMP0/Branch0 1.55V 2GB DIMMx4
/Branch1 1.55V 2GB DIMMx4
CMP1/Branch0 1.55V 4GB DIMMx4
/Branch1 1.55V 4GB DIMMx4
# prtdiag -v
System Configuration: Sun Microsystems sun4v SPARC Enterprise T5240
Memory size: 48928 Megabytes
:
:
======================= Physical Memory Configuration ========================
Segment Table:
--------------------------------------------------------------
Base Segment Interleave Bank Contains
TABLE 3-4
Firmware and General Software Issues (Continued)
CR ID Description Workaround