Appendix A
Fixed Issues
109
For DC Input Power Models, the Output From the
showpower -v
Command May Differ Between
/SYS/PS0 And /SYS/PS1 (CR 6802433)
This issue is resolved by updating the system firmware to 7.2.2.e or later.
For DC input power models, the INPUT limit value included in the output from the
showpower -v
command may differ between /SYS/PS0 and /SYS/PS1. The
/SYS/PS1 value is correct.
[Example of s
howpower -v
command execution]
(*)
This is incorrect. The /SYS/PS0 value is correct.
Workaround: None. Ignore this issue because it is only a display error.
sc>
showpower -v
-----------------------------------------------------------------
Power Supplies:
-----------------------------------------------------------------
INPUT
OUTPUT
Power
Power
Supply
Status (W) (W)
-----------------------------------------------------------------
/SYS/PS0 OK 172.8 123.8
/SYS/PS1 OK 153.6 133.3
-----------------------------------------------------------------
Total Power 326.4
-----------------------------------------------------------------
INPUT
INPUT INPUT OUTPUT OUTPUT OUTPUT
Volt
Current limit Volt Current limit
Supply
(V) (A) (A) (V) (A) (A)
-----------------------------------------------------------------
/SYS/PS0 -48.0 3.60 37.20 11.9 10.40 99.20
/SYS/PS1 -48.0 3.20 8.00(*) 11.9 11.20 99.20
sc>
