Fujitsu SPARC Enterprise T2000, Installation Manual, Page: 49 / 88

Chapter 2 Installing the Server 23
FIGURE 2-12
Unlocking the Slide Rail Assembly
3. Inspect any attached cables for binding or kinks.
4. Verify that the CMA extends fully and does not bind in the slide rails.
5. Verify that the server extends fully and locks in the maintenence position.
The server should stop after approximately 15 inches (40 cm) of travel.
6. Pull both slide rail release buttons toward you simultaneously and slide the
server back into the rack (
FIGURE 2-13
).
The server should slide smoothly into the rack without binding.