Fujitsu SPARC Enterprise T2000, Administration Manual, Page: 38 / 98

16 SPARC Enterprise T2000 Server Administration Guide • April 2007
To install a local graphics monitor, you must have the following items:
■
Supported PCI-based graphics frame buffer card and software driver
■
Monitor with appropriate resolution to support the frame buffer
■
Supported USB keyboard
■
Supported USB mouse and mouse pad
▼
To Access the System Console Through a Local Graphics
Monitor
1. Install the graphics card into an appropriate PCI slot.
Installation must be performed by a qualified service provider. For further
information, refer to the service manual for your server or contact your qualified
service provider.
2. Attach the monitor’s video cable to the graphics card’s video port.
Tighten the thumbscrews to secure the connection.
3. Connect the monitor’s power cord to an AC outlet.
4. Connect the USB keyboard cable to one USB port and the USB mouse cable to the
other USB port on the SPARC Enterprise T2000 server back panel (
FIGURE 1-2
).
5. Get to the
ok
prompt.
For more information, see “Getting to the
ok
Prompt” on page 24 .
6. Set OpenBoot configuration variables appropriately.
From the existing system console, type:
Note –
There are many other system configuration variables. Although these
variables do not affect which hardware device is used to access the system console,
some of them affect which diagnostic tests the system runs and which messages the
system displays at its console. For details, refer to the service manual for your server.
7. To cause the changes to take effect, type:
The system stores the parameter changes, and boots automatically when the
OpenBoot configuration variable
auto-boot?
is set to
true
(the default value).
ok setenv input-device keyboard
ok setenv output-device screen
ok reset-all