Fujitsu SPARC ENTERPRISE T1000, Installation Manual, Page: 76 / 84

50 SPARC Enterprise T1000 Server Installation Guide • April 2007
■ netsc_ipnetmask
– Netmask for the system controller subnet
Note – For more information on configuring ALOM CMT, refer to the Advanced
Lights Out Management (ALOM) CMT Guide.
To configure these parameters you must use the
setsc
command. The usage is:
1. Set the netmask for the system controller.
This example uses
255.255.255.0
to set the netmask. Your network environment
subnet might require a different netmask. Use a netmask number most appropriate
to your environment.
2. Set the IP address for the system controller.
3. Set the IP address for the system controller gateway.
4. Set the
if_network
parameter to
true
.
5. Use the
showsc
command to verify that the parameters were set correctly.
The
showsc
command displays all the configuration parameters and their values, as
shown in the example below.
sc> setsc
parameter
sc> setsc netsc_ipnetmask 255.255.255.0
sc> setsc netsc_ipaddr
service-processor-IPaddr
sc> setsc netsc_ipgateway
gateway-IPaddr
sc> setsc if_network true